I installed my kit with no issues. Easy to follow instructions. Works very well on my Ruida controlled laser with lightburn as the software. Much better than my "manual" adjusting of air that was provided by the wheezing little onboard air pump. Hooked to my shop compressor, cutting and engraving results are far superior. I'm not affiliated with Artifex - but credit where it's due - it's a good bit of kit and I recommend it. Cheers from Australia.
Great video! Just got my kit, looking forward to installing it. Would also love to install a stack light. Do you have a source for them and a video to install?
Yes this is normal when the machine is unpowered with the normally open solenoid. There is a manual valve to turn off air completely is the laser is unpowered.
I did get my order, and it works great! Installation went smoothly. The only part that I didn't enjoy was drilling a hole in my brand new laser for the switch, but that's not Laser Artifex's problem.