The instructions were very good for assembly. But you should tell us which blades to use for what jobs. Also, when or why to use the smaller protection guard versus the large one with wheels. I'm going to try to find the sales ad on Facebook and see if there are any clues there; I seem to remember lots of demo videos when I bought the machine.
I’m pissed! The large shield has 2 small and 2 large openings to seat on unit. How can you line up the holes for the screw ( shield to motor when the cutouts on the shield don’t match the tab placement on motor??? Plus, this company is well insulated from customer calls for help. Save yourself the frustration!
Could you please consider using a wrench to tighten the screw? The blue stop on the nut is intended to prevent the screw from falling off automatically.
One of the wheel nuts was cross threaded on there and difficult to get off then to go back on. They did not say where the washer goes on either of the instructions for the two different types of washers. They should have also said something about which side goes on first with the lock safe nuts for the wheels. The screw to be removed for guard installation would not come off. It was too tight for the tool provided. I managed. It is assembled now. However, 1 question, was I supposed to put the small guard on around the front, as well as the large guard around the front? I could not find where to plug the battery charger plug into the battery. It would have been helpful to mention that as I have not had batteries charging like that before. Looking forward to using it now. Thanks.