Noticed something interesting that wasn't included in the description for the boards I ordered. Found this after checking other seller's listings. These boards have an internally shorted VIN and OUT+. OUT- is switched so if you have a common ground, the OUT/LOAD will always be on. If you are trying to use this to delay a vehicle backup camera shutoff like I am, it doesn't work because all ground connections are common. In other words, the backup camera will always be on no matter what.
You would need two boards to control two lights trigger only tell the board to active power to output but you can have multiple lights from trogger depending on your power source and just have individual on/off switch for each lights
Hi I have a question please does the ground for the out/load - have to be different to the ground for the ground 12V ? (Both the ground on the left of the board
@@soarerloverify so if I use same ground for input 2 & 4 on the right of the board the circuit would still function correctly and switch power on and off after OP set time
@@soarerloverify P1.1: signal is triggered again, invalid Currently I have my input signal which is 12v and stays on until it loses power from another switched relay. On the right of the board I have 12v permanent and ground (which shared with my load ground) then my output + to my unit/load which is already grounded separate. Would this set up work on mode p1.1 to trigger power for 10 seconds to my unit/load then go off and not provide power again to my unit/load on output + until the signal trigger is lost and re triggered please Thank you for your reply really appreciate it 🙏
@@sarooprinceany amount of time you want just need to set it up in setup mode. Double check the wirings setup shown on the video wrong wirings can damage the unit.
