Lee Turret Press, Primer feed setup 

I did this video for someone that asked about it, I figured if one person had problems, there were more. I'm glad you found it useful, and thanks for commenting.

Glad it was useful, another viewer requested this video so I figured there would be others that it would help.

Not hard to use at all. Just set up each station and let it rip. I loaded 500 9mm after this video. Feel free to ask any questions.

Glad it was useful, remember to always use published load data from a reliable source.

I think it saves quite a lot of time once it's set up well. I have the older setup, the new one may be different, just take the time to set it up and you shouldn't have to adjust it again, I recently loaded 2000 rounds of 9mm without an issue.

Glad it was useful for you, thanks for watching.

I'm glad it was helpful, I did this video in response to a viewer question.

The pin is in the ram, there should be a notch on the bottom of the primer arm that goes over the pin, basically gravity holds it in.

@@FatManLeather ok. Thanks for the video and reply!

Thank you much.

I still use a single stage for a lot of my reloading. I'll have to remember that when these give up on me.

Thank you.

Glad the video was helpful.

I've never had to return anything to Lee, I know they don't have the best warranty in the biz.

Much appreciated.