@@MR.OOFofficial Hey so i dont have this what i think is a knuckle arm of some sort but can you tell me the name of the peice that makes the piston turn over please would mean alot
This “supercharged” engine doesn’t do anything the charger is to boost the engine not just spin paddles… The super charger should be atop the valve so that when the valve goes all the way down “letting the piston exhaust escape” and blocking the vacuum to piston chamber, should only the turbo or supercharger blow air into the piston chamber to then push down the piston faster to then pull the valve up faster to then start cycle over again
The super charger should be atop the valve so that when the valve goes all the way down “letting the piston exhaust escape” and blocking the vacuum to piston chamber, should only the turbo or supercharger blow air into the piston chamber to then push down the piston faster to then pull the valve up faster to then start cycle over again. AGAIN… ITS NOT HARD TO UNDERSTAND ITS JUST A BELT DRIVEN TURBINE NOT DOING ANYTHING NOT BOOSTING NOT ONE PEICE OF THIS ENGINE MATTER A FACT ITS SLOWING IT DOWN
@@TheLegoPro1234 sorry bro this was a long time ago, I already destroyed this little engine, but this is the video where I got it from, hope this helps. LEGO Vacuum Engine Tutorial - HIGH PERFORMANCE
I’ve got for sure the fastest Lego 1 cilender motor vacume ever but as hard as I try it can’t do full throttle more than 3 seconds before it just blows to nothing and some times the parts get destroyed to
@@MR.OOFofficial Noooo!! do not sand down the sides of the wall near the piston, it will make the two airs collide (bottom and top) in return making it worse plus, you'll need to get more pieces I'm an engineer, and I would know.
They do kinda have a cold start to them. The plastic contracts after awhile. Once the engine has run for a good bit and has been maxed 2 or 3 times, the plastic gets warm enough do to friction to put less friction on the piston and therefore starts easier.
Buatifull to make it have beter preformance have the vacum empty and take a lego rubber whell pop out the wheel and put on the rubber on the tip of the vacum
Maybe it’s the housing of your cylinder of parts trying loosening things up, give it some play put some oil inside the engine for it can smoothly go up and down 👍