Leister Tutorial | Hot-Air Blower Hotwind System operate and options to control and hook up

Подписаться 3,4 тыс.

Просмотров 10 тыс.

50% 1

The video shows, how to operate and setup the Hotwind System and how the different modes works, with and without an external controller, in open and closed loop. You will see how to connect the Hotwind System proper with the signal wire and the alarm contact. The function of the alarm contact will be explained.
www.leister.com

Опубликовано:

28 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@ricardoduarte3443 2 месяца назад

Buenas tardes, disculpa en el minuto 17:43 tienes activado en la pantalla del controlador CSS una bandera que dice "OUT 1", pasan los segundos, se corta vídeo, y ya no aparece, cómo fue posible que lo quitaran? Queremos realizar lo mismo que el vídeo pero no responde la pistola al controlador, no logramos nada, no detecta nada, espero puedan ayudar, gracias!

@leister-tutorials 2 месяца назад

Dear Ricardo Out 1 is Alarm 1, which lights up when the value is exceeded. In the video, a value that was too low was probably first stored and then changed. That is why it went out. Best regards Your Leister Team

@krisshoup2580 Год назад

I want to control the Air Flow AND the Temperature independently via an external controller. Is this possible? I'm using an Omron CJ2M PLC and a 0-10 V Analog Output card.

@leister-tutorials Год назад

Yes, you can control the air flow and the temperature via an external controller (4-20mA or 0-10V). But you need one controller for the air flow and one controller for the temperature. And you need also for both 24VDC power supply. You can find more information on our homepage. www.leister.com Best regard Leister Team

@doaa9021 3 года назад

thank you for this information please if you have ERR NUMBER 8 what is kind of problem?

@leister-tutorials 3 года назад

Dear Mohamed It seems to be an electronic Problem. You have to send the tool back to our Leister Distributor in your country. They will send you an offer for to repair the tool. Please get in contact to your local leister distributor under following link www.leister.com/en/contact/General%20Contact Best regards Your Leister Team

@belkacembelkacem8161 5 лет назад

it's possible to control it with a Raspberry or an Arduino

@leister-tutorials 5 лет назад

Thank you for your inquiry. The input signal for the Raspberry / Arduino has to be made for the Thermocouple you use. We normally use the K-Typ Thermocouple which is an analog signal. Then you have to program the Rapberry / Arduino for PID controlling. The Outputsignal for the Raspberry / Ardunio has to be a analog signal too, like 4-20 mA or 0-10 Volt. So it will not be a plug and play solution, but it would be possible. Best regards Leister Team