First take out the wire of the actuator, then turn on the ignition switch,few second then turn it off.and Wire again check? same problam 4lo egaged and actuator problam?
Hi, thanx for your videos. I would like to ask if you have any suggestions if a scan message of "abnormal fluid pressure" appears. What can I do. My car does not change height now. It is stuck in "LO" mode. Everything was working fine. I change the 4 accumulator globes and refilled the AHC fluid. Bled the system. Now I get the message "check 4 wheel AHC system". What can I do if after a system scan it says "abnornal fluid pressure"? The ahc pump still works, but doesn't kick on. Suggestions how to "wake" it up. Hope you have a suggestion. Thank you very much
@@rizzfixx sorry, my mechanic did the scan and I did not make a picture of the scan code. I will check with him later. But many many thanx for your reply. I have been struggling with this for 2 weeks.
@@rizzfixx I am just done working on the car. Finally the pump from the ahc went on by itself. I unplugged the car battery for 2 full days and I lifted the car with jacks to simulate like it is in HI mode to let the ahc fluid go down by itself by gravity. And just before I plugged back the battery and started the car. And all of the sudden the pump kicked on and is fine now I hope. Still need to drive around to test. But the height control works again. After 2 weeks headache finally it works. Thank you again for the replies, I really do appreciate it.🙏
bhai jaan kya hall hai mere pass parado aayi hai 2016 model jab gear drive mein krta hoon tu lagta hai uska 4wheel laga hua hai aur jab jeck oe gadi lagaya to fr wheel free hain aur meter mein 4 lo ki warning light aa rahi hai aur scanner mein bhi show nhi kar raha
Thek bhai ap thek hain..gari chalne me bhari hai or 4lo light blink kar rahi hai to phr 4lo laga hua hai eska hal yehi hai actuator khol k timing set kare..
What’s was the fix in the video? Can anyone pls describe it here? I wasn’t sure but looks like it was just disassembled and checked and then put back together? Didn’t notice any replacement of parts, contact cleaning or regressing? I’m encountering the dreaded check vsc system and 4Lo lights and was thinking I need to open up the actuator housing and check for corrosion etc