Light-O-Rama PixCon16 Controller - Basic Configuration 

So I have a question. I have a CTB16PC Controller that I use. I also have a Intelligent E1.31 RGB 16 Output Controller that is my mega tree that I have been using the both work just fine. I bought a Intelligent Pixie RGB 16 Output Controller so i can run RGB Intelligent RGB Pixels 50 count (like around my porch posts etc). I also have the S5 Pro Version Software from wow lights. I cant figure out how to get my new Pixie controller to work/added to my current sequences (I have bought all my sequences from wow lights). I'm so lost on that to do, I was able to set the box in my office use the high speed usb485 adapter and get the lights to turn on etc. But I cant figure out how to use the controller in my show/sequences that my CTB & Mega tree uses.

Is another Pixcon16 a DMX controller? You mentioned around 3:00 mark that when running in E1.31 mode that you have four outputs for DMX controllers.

Can you explain the jumpers on the board if using LOR network? For instance do all 3 pin jumpers for all 4 DMX/LOR need to be on LOR?

It the setup similar to the pixie 16? First year Doing LEDs!

No matter what I seem to do, the Find/Configure PixCon16 doesn't ever find an IP address. It comes up blank every time. Is there a tutorial that could help with this issue?