lowpass Crossover | Subwoofer Passive Crossover | 300 Hz Low Pass 8 Ohm Crossover

Подписаться 3,5 тыс.

Просмотров 3,8 тыс.

50% 1

To make a subwoofer for an 8" speaker, I made this second order low pass filter. This video shows you the detailed process from making inductor and PCB to completing the finished product.
Hope you like this video, please subscribe, like and share.

Наука

Опубликовано:

27 фев 2023

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 11

@PRAR1966 Месяц назад

🙂

@carlosconde4096 Месяц назад

Please show how to make 2.7mh inductor

@seesomethingnew9856 4 месяца назад

hello how can i make crossover for 5-10w woofer?

@bryankinggines523 11 месяцев назад

Hi. Could this be use to a 18 inches 1000watts speaker?

@stelectronic645 11 месяцев назад

This inductor is wound with 20 gauge wire to handle 200 watts of power. I think you can use wire wound inductor above 14 gauge. Thank you for your attention.

@jeussmyrrho9119 9 месяцев назад

How many meters of wire did you use?

@stelectronic645 9 месяцев назад

I didn't measure, it's about 3.5 ounces

@jeussmyrrho9119 9 месяцев назад

@@stelectronic645thankyou for your reply, may i also ask what gauge of wire can i use for a 100 watts sony sub. Thanks

@stelectronic645 9 месяцев назад

It is recommended to use wires above 22 gauge

@jeussmyrrho9119 9 месяцев назад

Have tried this, but it's heating up, it doesnt do as much heat like it can melt the plastic tape, but hurts enough when you touch it, is it really normal or its something i need to worry about

@stelectronic645 9 месяцев назад

This is not normal. If the wire diameter of the inductor is too thin, or the power of the amplifier is too high, it will generate heat. The inductor can be wound with thicker enameled wire