This is the first part of the Sammalouf Rovec Chair manufacturing process.
I tried my best to make it according to the method in the production (DVD) as much as possible.
It is a little difficult to make while learning from DVD, but I think it will be a fun experience.
I will show you all the trial and error parts during the production process.
I thought about releasing the video after I finished all the chairs, but it takes too much time, so I'm going to upload it in several parts.
Please look forward to part 3
00:00 start
00:15 Draw a mark on the part in contact with the seat plate
00:32 Drilling screw holes for fixing the legs
01:36 Selecting wood for each part
01:11 Cut the unnecessary part of the front leg with a band saw (1st)
01:41 Cut the unnecessary part of the hind leg with a band saw
02:23 Cut the unnecessary part of the front leg with a band saw (2nd)
04:12 Leg temporary fixation
04:26 Cutting wood for the backrest
04:44 First three-dimensional cut of the backrest
05:13 Second-dimensional cut of the backrest
05:45 Drilling a piece hole for fixing the backrest
06:02 Cutting nails for armrests
06:34 Aligning the rear leg and armrest angle (1st)
07:40 Align the rear leg and armrest angle (2nd)
08:38 First three-dimensional sawing of armrests
09:16 Armrest assembly
10:14 Drill a hole for a dowel pin for fixing the armrest (front leg side)
12:06 Armrest 2nd stereoscopic sawing
14:11 Drilling a piece hole for fixing the armrest (on the hind leg)
16:18 Temporary assembly (without bond)
#SamMaloofLow-backChair
#LowBackChair
#ComfortableChair
Advice and suggestions are always welcome.
If it helped a little
Please "Subscribe", "Set notification" and "Like".
▶ youtube "enjoying woodworking" Free Subscribe
bit.ly/2LI9Apt
BGM :
* RU-vid Audio Music Library
29 июн 2024
