#makeblock #laserengravingmachine
I finally finished building my custom enclosure for my Makeblock XTool D1. I had some mistakes in my wood cuts and some other minor issues but I was able to make adjustments. Overall I’m happy with the outcome. This video is not a tutorial but it shows that if you put in effort into something you may be able to get what you want. The list posted below should serve as a starting point for fellow noobs like me who can’t spend a lot of money on an enclosure. It’s not strict and you can customize as needed and swap out parts to fit your specific needs.
Structure - Plywood (thickness depends on your preference)(Home Depot)
1. TOP COVER - 26 INCH HEIGHT AND WIDTH
2. BOTTOM BASE - 26 INCH HEIGHT AND WIDTH
3. FRONT WALL - 12 INCH HEIGHT, 26 INCH WIDTH (SUCTION FAN HOLE IS 4.5 INCHES)
4. REAR WALL - 12 INCH HEIGHT, 26 INCH WIDTH
5. LEFT WALL - 12 INCH HEIGHT, 26 INCH WIDTH
6. RIGHT WALL - 12 INCH HEIGHT, 26 INCH WIDTH
7. SCREWS DEPEND ON THE THICKNESS OF WOOD YOU USE (you’ll need about 50)(Home Depot)
8. HINGES - (EVERBILT NARROW UTILITY HINGES, 1-1/2IN, 2 PACK, NON-REMOVAL PIN) (Home depot)
9. ACRYLIC ORANGE (double check for laser filtering): amzn.to/3DCyqAD
10. HONEYCOMB BED (OPTIONAL): www.ebay.com/i...
11. EXHAUST HOSE: amzn.to/3ctQ5ym
12. SUCTION FAN: amzn.to/3HGChPg
13. Foam is from D1 packaging box
If you have any questions, I don’t mind. Please ask in the comments below and I’ll get to it as soon as possible.
15 сен 2024