Maytag Neptune DC Dryer Lint Clean 

A HUGE THANK YOU!🙏 You Sir, are a life and time savior! I ADORE my DC. I’ve had it for almost 20 years! We’ve used your video numerous times and so appreciate your tutorial. Wishing you and yours A very Happy New Year!!! Salutations from Kentucky.

Perfect, Thank you!🙏🏾. Was expecting to find the inside filled with lint but it wasn’t that bad. The section where the lint trap goes is rather tight, I used the wand of a swiffer duster to get it all out and it worked great. Bonus, shifting the washer to clean out the lint from the behind the dryer resulted in the washer being perfectly balanced and now the spin cycle is virtually silent. Something finally worked out in my favor.

Thanks! That helped a lot, particularly since I also needed access to the electronic board to make some mods. By the wire, the yellow wires on the right are for the humidity sensor.

I just took my dryer apart and cleaned out the lint ... thanks for the video!!

This was amazingly helpful! Great tutorial!

Thanks for your video. I have this dryer. Such a pain to clean the lint run! It would make so much more sense to have a panel that opens below without having to remove the whole control panel! 😂

I believe the yellow wires on the right are for the moisture sensor.

Thank you so much for your video. It helped a lot..

Thank you so much you help me and save me money 💰

Awesome information, thank you!!!!

Hello, if the dryer at the bottom stop spinning and I need to replace the belt. Is the access available through the side of the dryer bottom?