Mazda MX 5 (ND) Side Mirror Replacement (Heated Mirror)

Подписаться 41

Просмотров 10 тыс.

50% 1

Replaced the side mirrors so I could have heated mirrors. Once installed, when you press the rear window defrost, the side mirrors will heat.
I have a 2019 MX-5 Club. 2016-2019 Should be the same. Not sure if the Sport edition allows for this. Check the wiring diagram or see if there is a fuse for heated mirrors. I followed the instructions here: www.hexorcism....

Опубликовано:

10 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 27

@lawrencefisher9767 3 года назад

Thanks for this. I have the same car, a 2019 Ceramic Club, and had damaged my right side mirror. You make it look easier than it was, for me. But having your guide made it far easier than it would have been. The Mazda shop manual was very helpful too.

@eljefe1077 3 года назад

Glad it helped you out. :)

@elbukiss Год назад

Thank you very much for this, it was very helpful for me replacing the side mirror, I was lost in whole procedure. Im from México! Saludos amigo!

@keithgoodway9077 2 года назад

used this video to help with changing my broken mirror, it was a great help, would say you don't need to remove the whole window, just the quarter glass, makes this much easier job.

@adriancort3s295 2 года назад

thank you very much for the video, it helped me a lot 🙏🏼😎

@miguelcrisol3273 2 года назад

Thanks for your video, the loose bolt of the windows that you show is a problem with the rattle on the windows when the road is not firm...

@Courtathor 4 года назад

Could you change the mirror just by removing the quarter glass, or does the window need to come out too?

@eljefe1077 4 года назад

Adam Court the quarter glass wont come out unless the window is out.

@Courtathor 4 года назад

@@eljefe1077 did you need to do the steps in the service manual to do with the pressure sensor, or was it a case of just reinstalling the glass and it all worked fine assuming it was aligned on the 3 nuts correctly?

@eljefe1077 4 года назад

@@Courtathor I'm not sure of what pressure sensor you're talking about, but I did try to align the 3 nuts. I should have marked them before I unbolted them, but there was marks from before which aided me.

@mhk1058 4 года назад

@@eljefe1077 Yeh, there is a pressure sensor for stopping the window trapping your head/hand/child etc and also letting the car know when it's closed. I think it also plays a part in the partial opening etc when dropping/closing the roof. The manual tells you to be carefull with it as the air bag can go off if mishandled! There is a bit of a rigmarole in the manual to set this up but if you do as you did and put it back exactly as you found it all should be good.

@mhk1058 4 года назад

BTW, did you disconnect the battery? I know you are supposed to to but I generally don't until absolutely necessary so just ondering if you needed to?

@camarocraig7060 Год назад

I figured out a way to do it in 10 minutes! Video coming soon

@eljefe1077 Год назад

Awesome. Hope the quality is better than my one hand holding one hand doing it.. lol Look forward to seeing an easier way.

@mrtravelfrog Год назад

Need to know more :)

@camarocraig7060 Год назад

@@mrtravelfrog pop the rubber loose in front of the small angle window (which is the front track) remove all of the bolts on the front track (top and bottom) push the track forward until the window is out of it, push it in to get the top stud out of the hole, rotate it 90 degrees and pull it straight up, ezpz. I can do it in less than 5 minutes now. All of the remove the window bs is ridiculous. Re install is exactly the reverse.

@mrtravelfrog Год назад

@@camarocraig7060 This worked very well. Thanks for posting this. Replaced my mirror today only pulling the quarter window out :)

@camarocraig7060 Год назад

@@mrtravelfrog awesome!