Mcculloch ring cleaning and set the end gap 

Love that hat buddy.

Oh, and thanks for putting the camera on the work being done! You don't do it all the time but it's appreciated when you do!

Goodmorning Bell hopper. Alabama likes those macs. One of the few i want but havent bought yet. Wife says l dont need as she laughs.

G'mornin' Bell hopper and all you hopperheads out there! Jereme we love the videos yer puttin' out. Kinda like hangin' out with a good buddy and shootin' the breeze before I start work☺. Thanks for bein' a good guy brother.

Howdy Jereme. Thanks fer the vids. You got the best hello in the bidniss

Morning Hopper!!!! Have a great day 💛🖤💛🖤

I'm a automotive technician we share alot of techniques that apply to engines in general. thanks for the great content.i found you thru buckins channel btw.

You know I need one of them hats

Hello Andrew thrush wife. There's an echo here. Lol. Welcome everybody.

Helloooo Hopper and Andrew. Another good lesson today. Hope you all have a good day 🤘

Thank you for the great information. Have a great day!

We gotten started early this morning

Gooood morning, Bellhopper!

Been watching for a while finally a new sub. Enjoy your information. Thanks

Get er done! The devil is in the details, quality work!👍👍👍👍👍👍👍

your on to it brother, ill say again brother, your the man

I love your new hat!! I would like to pick up one myself. Talk to you later, have a good one!

Good info Jereme. Yep nice hat 👍✊

NICE tutorial buddy learning lots thanks BELLHOPPER have a great day buddy

Hello

Good info, thanks for showing this hopper! Ready for the big game Sunday?

Good morning professor Jereme Bell hopper! So you would use 32:1 on old and new saws too help prevent the carbon? What are your thoughts on 40:1 or 50:1 ? Another great video, seemed like your camera was focusing in up close better. Enjoy learning from you! Thanks

Do replacement rings come over-size, or do you buy "special" oversized ones to file down. thanks for sharing.

I’ve got a 1-52 fixing to put rings in it where do you find factory rings at cylinder and piston look good bearings feel good to just compression is low and hard to start

Best way to break in a fresh build? Limited idle, ease into it under load? or are you a wide open throttle kinda guy? lol

Helloooooooooooo Bell Hopper !

Looking good my friend. On the older saws, are they iron sleeved?

what ring gape would you set the Pop Up piston rings too, the Cape Rings sent, .010

What’s the correct ring gap for pro 10-10

Where did you get your rings at?

I would hate to see your floor. Your spiting on the floor is grouse especially on camera for everybody to see.

Hello