Mercedes E-Class Center Vent, Passenger Trim and Glove box removal.

Подписаться 789

Просмотров 15 тыс.

50% 1

Created by InShot:inshotapp.com/...
Vehicle: Mercedes W212 E-Class 2009-2016, maybe some details apply to W211.
Important note: To remove the glove box, remove the passenger trim and center vent completely. I realized this later. Watch the whole video as some details are covered later.
If your glove box light isn't working and it's not the bulb, this video shows the probable cause - a design deficiency common on these models where the wiring breaks at the plug to the switch. Info on pin and plug numbers for repair shown. The pins are removable so you can reuse the plug.
This is not intended to be a professional video. It is filmed raw and I'm learning along as I film. But I try to focus and explain all tricky parts. I hope it helps you. Like, comment, and subscribe.

Опубликовано:

2 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 11

@MichaelDating-br1zf 5 месяцев назад

Hey RU-vid. You really expect me to watch three fucking minutes of adverts to get to what I actually want to watch?

@pfsantos007 5 месяцев назад

I know it's a pain, but that's what they do. I get no money for it.

@Jagogjk1 3 года назад

Where is my finger ??? 😂😂 It sounds you were having a hard time getting the glovebox out.

@pfsantos007 3 года назад

First times are like that 😁😁😁

@dodo-eb7by 2 года назад

Hi. This video was really helpful for my w212 glove box removal. Thank you. If I could ask :- How did you remove the little wiring block into which the purple and green wires connect to the microswitch? Is there tab that releases it or does it need a good yank to get it out or does the hole switch need to come out? Also, about how much extra wire did you add , an inch or two perhaps?

@pfsantos007 2 года назад

It's been awhile so I don't exactly remember but I believe there was a tab. Did not add to the wire just peeled back some of the black felt.

@pfsantos007 5 месяцев назад

Doing this job again. 3 years later. Adding more wire. No tab on plug.

@ADPTraining 3 года назад

This video saved my life. Radio wasn't working. I had to LOOP or bypass the MOST Fiber optic network at the Media Interface Module behind the glove box. Look elsewhere on YT for fiber optic Loop. As soon as the MI was bypassed, radio came online. Thanks Paul Santos.

@druppy12th 9 месяцев назад

Thanks Paul you're video help me a lot

@pfsantos007 9 месяцев назад

You're welcome!

@Dnasty1 2 года назад

I bought one of these on ebay and of course the light doesn't work. I replaced the bulb and still no good I'm guessing its the switch. Was wondering what the part # for the switch is so I can order it before taking it out.