That bit of steering jitter at the end, for me adjusting the steering expo from 10%-35% usually stops my jitter. Just makes the steering receive no voltage until the wheel is turned left or right a percentage. Axles look great!
@dublintwentyfour7163 Okay! Makes since👍🏾 Nice to know now. I've done upgraded servos.🤣 I did upgrade. But I went with something with a lot more power. Thanks for the tip and thanks for watching.
O.G. for real! Thanks a lot for commenting on my truck...I really wanted to make it look cool and a little scale. Like your channel... you got some skills! I need all the help I can get! Will be watching!
Those look very well made. The steering angle is much better than the typical axles. If you put your hi/lo tranny back in it should correct the drive shaft angle and less weight up high. Very nice upgrade!
I've been thinking about that trans again. Or something similar. I want to find a premium trans . That angle seems to be running fine in the backyard. Do you think that driveshaft angle will cause issues?👍🏾
@@OGRadGrow It'll be fine for quite a while. They just tend to wear out faster when more angle is involved. It should be goo. The other tranny is lighter which is nice when climbing and side hills. You know what you like!!! Git - r - dun!
@@OGRadGrow Keep in mind though....you can change gears in both axles still in order to change that ratio. But I don't want to hear that noise again either, LOL!😆
@samlopez455 They did replace them but charged me like $5 shipping. The new set seems to be doing fine. Believe me, when I tell you, I TESTED these new ones.