Some People Are getting Same Problem in MI Water Purifier If your purifier stops working after some time than Do the Following steps Step1: Open the Filter Lid Step2: Rotate the PPC Filter(first fiilter) to the unlocking side slightly ( Just a little bit of twist ) Step3 : Reset all the Filters using filter button your purifer must be working again atleast this worked for me
Any body who is having this problem can text separately. Its normally some other problem but we always think it is to do with the water pressure, water pump, tds, filter expired etc , but its not, please let me know ...happy to help
My water purifier will stops automatic after filling 1.5ltr of water I think the level sensor has issue I have unplugged the sensor cable but still same issue could you pls help me out
Are these level sensors available outside Mi? Same problem with my purifier. Shuts off 5 secs after turning on. Disconnected the level sensor for now. It’s filling up now. Have to shut it off once it starts overflowing.
Nice video, I changed all the filters. The purifier is working ok but for some reason it fills around 4.5ltrs and then stops. Earlier it would fill upto the 7ltr capacity, not sure what the issue is. Any suggestions?
Bhai mera mi water purifier me har 8-10 minute bad purification off ho jata hai ? Restart krna padta hai to chalu ho jata hai ? Kya problem hai aap bata payenge
Spend thousands of rupees on this purifier! Recently got some part fixed from the service centre guy and just after a week it stopped working, now the same guy is asking 3000inr for the sensor (official mi guy) I recently bought the filters too I removed the sensor by myself after watching this video and its still not working. Going to trash it now! Now Im really confused which purifier should I buy? Also I just recently came to know about that we dont need RO in Mumbai! UV and UF is sufficient
My mi purifier restart continuoly. 1,Interchanged ppc & pac filter. Worked for some time then issue came again 2, cleaned sensor with lime. Worked for some time then issue came again What is the solutiin
Helpful video.. thanks.. I bought this and I want to somehow avoid water flow through RO cartridge.. is there a way to seal the water entry-exit points to/from RO cartridge ? Thanks again!
Can we empty contents of RO cartridge and connect it as empty? OR can we directly connect inlet and outlet of RO cartridge so that water doesn’t flow down inside RO Cartridge ?
My mi ro is not working properly. It restarts again and again . Please help me . Service centre does not help me. It stopped working in 1 and 2 minutes . Sometimes it works whole day.
Just put one 500ml white vinegar in the tank and fill the rest with pure water. Let it soak overnight or more if possible. Make sure entire sensor is filled with the vinegar water. Then drain the tank, the water sensor will start working.
I'm getting very high tds after changing all three cartridge any solution. input tds is like 600ppm and output 550ppm it was working fine before changing the cartridge. any solution
1, Restart Problem==Check Adapter 2, Motor Working But drainage water not coming out == check ppc filter 3, water not filling in the water tank/ half filling == change water level sensor check below link for water level sensor repair 2024 ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-w1et1DdEWCk.html
