Mini 1300 Vector Network Analyzer - Calibration with Factory Kit 

Just got my Mini1300 on friday after 3 month of waiting. Can't say thank you enough for your videos !

Did not find anything on the Internet about calibration Thank you I helped you! Thank you from Siberia!

Thanks for taking the time to make and post this video

Guy has a killer voice!!

Fabulous video, thank you - you've single handedly filled a huge gap in the user manual technical info. 👍 Regarding the HW Cal, is this a simple touch-screen button pressing exercise (once only) or are hardware configurations required (switch/es) inside the mini1300? The reason I ask is because, in my drive for online information I've found the FAA-450 EU1KY analyser with a good manual, and whilst this kit is not exactly the same as the mini1300, it's archetecture bears a striking resemblance. In the FAA manual it talks about changing a jumper on the RF board to do the HW cal. Thanks in advance. 👍

I don't know how to tell which dummy load that comes with the kit is the 50ohm load

I LIKE YOUR DISK 😁😁😁

Which cable can I use for Calibrate S21 Gain Calibration, simple a coax cable 50 ohm between VNA and Test Port?

Does any one know what the values are for the surface mount resistors they send with the unit . i got them solderd on but dont know wich one is the 5ohm 50ohm or 300ohm

If you save the calibration, can you avoid needing to calibrate at each use? My SAA-2N says to calibrate each time, even though there are several save slots for saving the calibrations.

where could you buy the calibration sma adaptors -

This is the best and only English explanation of calibration I have found, thank you so much for taking the time to enlighten. Question: Do I run Hardware Cal (only on first run) first or was that done at factory?

Hi there, would you mind giving me the measurements of the screen, hight/width please, I don't know if the measurements given are diagonal or not. All they seem to say in sales blurb is that it has a 4 inch screen. Many thanks

Price is up there with conventional analyzers. And its really just a nanovna.. so idk ?

You didn't show which stub to use for what calibration.

Anyone use this on their 23cm setup? I seem to have SWR results that are all over the board. The unit goes berserk above 1000mhz even into a dummy load. Anyone have any success?

Mohon dalam terjemahan bahasa indonesia agar kami bisa lebih mengerti

After intro, Started at about 0:35 without any setup info and totally skipped the initial calibration into 5 ohms. May be a problem but NOT good!

Nope, I'll buy the Rig Expert

Please do another video but without the thumping "background" music. It's not necessary in an instruction video.

Any information about what you were doing or using would have been great. As it is, you owe me for 5 minutes of my time.

What’s up with the Asian culture bow? Cultural appropriation?