Morryde SRE 4000 Install And Bracing/Welding Suspension Hangers 4K 

I just put mine in 2 years ago and they failed on trip home last month- rubber suspension part almost all the way out on one and nearly on the other-they both looked fine before leaving Florida for RI Thank god they did not collapse on the road.....

Did I miss the part where the braces going to the hangers from the opposite side of the trailer were installed?

My 2020 Outdoors RV 280RKS CANNOT mount the Morryde X-Factor Cross Frame due to blocking interference of the Propane Line running down the right side of the frame....The Front and Rear Hanger bolt holes will not align with the X-Factor mounting bracket bolt hole due to propane line interference. How did you get yours installed correctly?

Needle nose pliers work great for removing the plastic bolt liners.

Cool, I did the same thing with new springs also, I used the 3000 it did rise my trailer up almost 2 inches, I still need the cross bar, I have the spread axle travel trailer so turning can be hard on things, thank's for sharing, best detail video yet.

Thanks for the walk through. Would you do this kind of work with slides out? or would you bring all the slides in? I'm concerned about where my family is going to go while I'm working on the rv.

Nice video. Thanks looking to upgrade my TT in the spring.

Awesome video!

A good practice with wet bolts is to shoot some grease into the bolt before installing to make sure the grease path is clear. I have seen cross holes miss the mark or foreign objects get in the holes and block the grease flow. At that point you have a dry bolt. Just a thought!

Good job I’m a welder my self and I’m doing the 3000 on my keystone passport 268 BH I like the your idea of backing up the spring mounts with a rear plate that will stiffen it up a bit I don’t have the side plates on my mounts But not a bad idea maybe a vertical gusset on the inside away from the tires all in all good job I’m going to weld in a 2x2 piece of tube across so I don’t have to buy one it will give the mounts a lot strength don’t you agree

Okay, this is a pretty good install I have one question on my Jayco it come with the CRE3000 from the factory do they make a upgrade for that, I mean since my is a 5th wheel is there an upgrade, looking at the 4000 in look like those are a little bigger than the one I have on mines? I don't know if Jayco uses the plastic bushings, I have a 6000 plus miles cross country trip coming up in March I am getting my bearing repack so I should be good on that but do I need to or can I upgrade the bolts?

I have the MoRRyde CRE3000, on my 21 303rls Reflection and adding the MoRryde x-factor crossmember. How important is “boxing in” the shackle hangers? And would you only be boxing in the front of the front shackle hanger and rear of rear hanger? That part of your video wasn’t clear. Thanks for the info!

Can you do a comparison between Morryde suspension kit and LCI kit?.........I have just purchase 2019 Coleman toy hauler and have the room for the higher lift, but do not want to because of the ramp angle. thank you for any help with this.

Did this lift the trailer any? I’m needing to lift my 5th wheel an inch or 2.

Berapa harga nya sampek indonesia?