Learn how to use Multi Channel ADC with STM32 Microcontroller. We’ll program ADC to read multiple ADC channels of STM32 Nucleo board. This project uses DMA and Interrupt along with ADC to sample multiple sensor data. In the end, we’ll measure light intensity using LDR and variable resistor using POT as an analog sensor.
[SUPPORT]
►► Try the world's most trusted PCB design software, Altium Designer with 365, for free and 25% off your purchase: www.altium.com/yt/binaryupdates
►► Free search engine for the best quality components from Octopart: octopart.com/
►► Learn about Altium 365, the electronics product design platform that unites PCB design, MCAD, data management, and teamwork: www.altium.com/altium-365
[RESOURCES]
►► Need Help? To Learn Embedded Systems: courses.binaryupdates.com
►► Single Channel ADC: • How to use ADC in STM3...
[TIMESTAMPS]
00:00 Introduction
00:16 Altium Free Trial
00:47 Create new project
01:28 Configure Multi-channel ADC
03:04 Configure DMA in ADC
03:48 Configure NVIC Interrupt
04:30 Configure UART
05:04 Write code for ADC Multiple Channel
15:03 Connect LDR and POT with STM32
16:26 Upload the code on STM32 MCU
16:42 read multiple analog sensor values
18:05 outro
17 июл 2024