MV Agusta Brutale, Dragster, F3 | How to Register New IGNITION KEY. 

MV Agusta Brutale, Dragster, F3 | How to Register New IGNITION KEY.
#mvagusta #mvagustabrutale #mvagustaf3 #mvagustamotor #poweredbytuanosen
“IMMOBILIzER” Mode
The “IMMOBILIZER” lets the engine start only if it
recognises the original starter key. This is actually an
anti-theft device built into the electronic circuit of the
vehicle, since only authorised people are allowed to
drive it.
Use the dashboard “IMMOBILIZER” only in the event
of a breakdown. If for any reason the original key is not
recognised by the system, to let the engine start you
must manually enter the secret code, which is on the
MV CodeCard that was handed out to you with the
motorbike.
- Remove the lid from the box on the back of the MV
Code Card and read the secret electronic code of the
starter key (the figure shows a random code, for information only).
- Access to “RUN” mode and press “SET” for over ten
seconds until “IMMOBILIZER” appears.
- Press “OK” for less than three seconds to set the first
digit of the code.
- Press “OK” for less than three seconds to set the first
digit between 0 and 9.
- Once the digit has been selected, press “OK” for over
three seconds to confirm the first digit of the code.
Now, you can set the second digit of the code.
- Do the same to set the other three digits of the code.
- Once the full code has been entered, “CONFIRM
CODE” appears on the display. Press “OK” for over
three seconds to confirm the code.
- If the entered code is recognised by the system,
“VALID CODE” appears. The dashboard display goes
back to “RUN”. The engine may be started.
- If the entered code is wrong, “NOT VALID CODE”
appears. The system will not let the engine start; the
display goes back to “IMMOBILIZER”. Repeat the
code entry procedure from the start, taking care of
setting all the right digits shown on your MV Code
Card. If the problem persists, contact a MV Agusta
licensed service centre.