My latest Upgrade 11 in 1 Impact Screwdriver/Nutdriver from Klein Tools  

I have been using this one at work the last few days, i'm really liking it. Good luck!

I work in industrial maintenance so I can't speak to HVAC work, but this is really just a more flexible 11 in 1 tool. I'm thinking I can take out the regular 11 in 1 and have a couple more option and save some weight in the tool bag! Hope it works out for ya!

@@jestermetalworks oh ok. I was thinking that it could work well if it had the features of the Milwaukee 13-in-1 driver with ECX. I would also add to it a couple hex drivers if at all possible for the pressure test ports on an oil burner and for opening/closing king valves on condensing units. The tool in your video does not look like that is completely possible with this setup which is also why I've been looking at the Wera Kraftform Kompakt which can hold the Klein magnetic 7-in-1 bit driver (1/2, 7/16, 3/8, 11/32, 5/16, 1/4) and the handle has storage for six 1/4 bits. Ideally they would be the hex as I mentioned, a small Phillips for thermostats, ECX (or square) for low voltage electrical, reg Phillips and slotted. For HVAC that would almost be an entire service bag in one tool regarding hand drivers, but I'm glad that you were able to make the tool in your vid work for you. Hopefully that clarifies what I need in a multi driver for HVACR

Hey check this video from @ReliableHVACR he shows a setup that may be more along the lines of what your looking for. ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-_Pdbtogy64M.html Hope this helps!

I haven't tried the racheting model yet, good to know

Mine is a little sticky on this one too.

Spray or wipe it down with some wd40 tool every now and then and it's good as new . At least it fixed my problem

I'm not sure this one is available on amazon yet, I think it's a home depot exclusive, that's where I found it. Just checked it says exclusive on HD here's the link www.homedepot.com/p/Klein-Tools-11-in-1-Multi-Bit-Screwdriver-Nut-Driver-Impact-Rated-32500HDR/322406283.

@@jestermetalworks Thanks!

Finally found one at a HD yesterday and bought it. Nice tool. I think I’ve got my new favorite screwdriver.

Yea I have used the heck out of this at work, It's my go to screwdriver!

I'm not sure, it's the standard hex shaft.

Not on this particular screwdriver, but I have had one come apart, but that was after a couple years of use.