I just did a video on a Voice controlled LED lamp at Dollar Tree for $1.25. You could use the small control board in the unit to turn on the cabinet display lights by voice command. It has mofette drivers that can drive LEDs directly or a relay. I shot a video where I replaced the built in 4 LEDs with 2 DC gearmotors that will come out in 2 days.
Ok that's pretty cool, I watched your video on Dollar Tree has a voice-controlled lamp for $1.25. Turn ON-OFF, DIM, Brightness & Color. So I will be looking for the other one you do. Thank you for the comments and the info on the light. And see if I can find it at my local DT store. 😄
Thanks for the video. I am no electronics expert so while I am intrigued, I am not sure if I can take on these mods. I was trying to see if all the resistors are joined together to one point to connect to the new ground wire or if they need to be separated, but I couldn't quite make it out.
I show on my wiring diagram that all the resistors are indeed connected at one end, that's the connection that goes to the new ground I made on the main board.
@@mikecomptech I was wondering if you could take a picture top down on the wiring on the switches, I can almost read the schematics. I have it installed, but not complete. Any help appreciated..
@@scottmcmillan711 Hi Scott congrats on getting the switches and mounted on the back of Zoltar. If you purchased the same switches I used then orientate them just like I drew them on my diagram I will post the pic on the NWT FB forum, so look there.
