Hi thank you for the info, Mine what it does is that it won't pass the 2,000 rpms when pressing the accelerator, keeps giving me the p0340 bank 1 I already replaced it and still the same.
This sounds just like what my 07 Nissan Pathfinder is doing,when I drive on the highway or wherever soon as there a slit load on it it starts to sputter ,give it a little gas and it stops for a sec then happens again,absolutely pisses me off🤬🤬
mine has no CHECK Engine Light and it will shut down on its own. Then i notice the instrument cluster rpm and Speedo needles would shake a little like if the ECM is acting up. But i have also heard that the Valve Body would Short out and cause the NEtwork to go down The CAN BUS to all the modules. Its so hard to trace the problem also cause it does it once in a while.. Has anyone on here ever noticed the Symptons ??? i connected my scan tool and there are no Codes From ENGINE, TCM, BCM, SRS and ABS they all report nothing . its the damnest thing ...
Same as you except it never turned off on me , I replaced a few parts and still no luck did you ever figure it out? Mine turns on and everything except it doesn’t accelerate nothing happens when I step on the gas pedal no rpm’s no rev it’s not in limp mode atleast don’t think it is
My 2008 Nissan Pathfinder will stall randomly. It’s not throwing any codes, no lights lit up on the dashboard. I paid a mechanic to clean the throttle body, that didn’t help. I took it into the dealership and after hours of diagnosing they came up with no answers. No codes to read. They checked the fuel system and all Is good there too. With no codes to tell, should I next try replacing the crankshaft position sensor?