Buenas tardes “ Señores muy buenos sus videos; solo le falta es grabarlos con audio ; ya q es fundamental el audio para interpretar mejor el video; muchas gracias
excelente video... tengo un problema parecido en el pin 8 tengo 7.8v y no arranca el integrado... ya cambie los dos trasistores y revise todas las resistencias... no puedo encontrar el programa
Hello bro,i changed all 8050 ,zener,6.2k ,22k resistor but i am getting 0.8v at 8pin of 3525 what could be yhe Resason,should I remove IC because that only left to change now
I have the same welder and I have 67 volts at the output but it has no current. The output diodes and triacs are fine, the sg3525 works correctly. I don't know where to look anymore
Boss what is problem for inverter welding machine 200a,250a,300a, after I change the four igbt, and I check the output voltage is 90vdc, when I test the sparking, immediately the igbt will explode back, sir what is the cause sir?
I recently got a Kzubr 400N MMA single phase stick welder which claims to (input 220v-36.6A stable, up to 47.6A max input)output 400A lol. Anyway it seems to be built solid and after further inspection I found that the real output is actually 200A which is still awesome considering I paid 120€ for it. Anyhow I have taken it apart and examined it and the insides look pretty identical but instead of the ground and stinger bars that are made of aluminium in the one shown in the video mine has them made of copper which was nice to see. Anyhow what do you think the life expectancy will be of my machine?
Hello I have the same problem on my mma 250 igbt welder. Pin 8 was reading low and I've removed j3y smd transistor and now it works. Should I wait for replacement transistor arrives or can I work with welder? Thank you
I have a welder machine which there is not output voltage. I tested 2 IGBT = Ok, 4 Diodes = Ok, 3 Polyester caps ok, 2 with 4.7 uF and 0.02 Esr and other 400v with 4.7uF and 0.03 Esr. Bridge rectifier is Ok. But, i haven't square waves in gate of 2 igbts. Thre wave it's similar to a part of senoid. Is the module the problem ?
@@lucasrocha4329 A short circuit on the 24V line and the power supply does not start due to overload, or the IC is powered off from the secondary circuit