NONE START TD5? Try this!

Empire Tuning - Land Rover Tuning Specialists

Подписаться 853

Просмотров 1,8 тыс.

50% 1

Commonly on older higher mileage TD5 models the crank sensor wiring sensor end can break down due to becoming brittle from repeated heat cycles and engine rock. This can lead to broken wires at the crank sensor end of the engine harness. which often causes intermittent running and starting faults down to a complete non-start situation, Avoid that with our sensor and overlay harness kit!
www.empiretuning.co.uk/produc...
✅ Service
✅ Diagnostics
✅ Parts & Accessories
✅ Harness Replacements
Instagram: @empiretuning
Snapchat: empiretuning
TikTok: empiretuning
Email: info@empiretuning.co.uk
Time Stamps
0:00 Introduction
00:59 Locating the Crank Sensor
01:26 Unplugging the ECU
01:45 Connecting the harness to the ECU
02:48 Fault Clearing (Nanocom)
03:20 Outro

Авто/Мото

Опубликовано:

5 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 13

@JimBiddle. 5 месяцев назад

Empire Tuning are awesome. Bought this same harness and genuine Lucas CPS sensor. Super helpful, highly recommend

@empiretuning-landrovertuni6535 5 месяцев назад

Glad you like them! Thanks very much!

@DanielJohnHowTo 5 месяцев назад

Nice work on the soldering etc and installation as well. Does remap require EGR delete along with specific exhaust part removal?

@empiretuning-landrovertuni6535 5 месяцев назад

The remap is built to your requirements and current hardware setup this means that if you have an Egr in place and exhaust then it would be a slightly less aggressive/powerful one due to flow restrictions

@DanielJohnHowTo 5 месяцев назад

@@empiretuning-landrovertuni6535 Thanks for your reply, keep up the good work. 👍

@robertgandorfer8307 5 месяцев назад

Hey Friends! Bought this kit from you and it looks ace! But can you give a recommendation for the pin-removal-tool? TIA!

@empiretuning-landrovertuni6535 5 месяцев назад

You can use a small pic, just make sure it doesn’t have a sharp point

@kevinmartin9432 5 месяцев назад

Excellent video, I think I may purchase a kit and install it, just for peace of mind! Are the wiring terminals numbered?

@empiretuning-landrovertuni6535 5 месяцев назад

Hi there! Yes! Everything is numbered. Full instructions are supplied with the kit!

@ashboy225 3 месяца назад

So, currently my crank sensor has no issues - Would there be any way for me to say remove my good sensor and "future proof" it? So it does not suffer the common damage

@empiretuning-landrovertuni6535 3 месяца назад

If it’s working i would leave it as is and maybe just buy the kit to keep just in case, of course you can fit this kit and it will solve any future problems however if it’s working its working