Nut and Bolt Design in Autocad 

Very straight forward, thank you somuch!

Really helpful. Thank you very much for such content.

Dear brother, While thanking you for the explanation I would like to point out about a small technical error. When creating the bolt, the helix should union with it and should not subtract. Otherwise the bolt will pass through the nut without any revolve.

Thank you Sir, is really helpful.

Thanks so much.I'm a beginner,and I see it very good

The Best Vedio I ever Found To Understand ❤

Really helpful. Thank you very much for such Bro......

Very nice but instead of the circle being the profile of your sweep, can you do this with a triangle for a more realistic looking thread?

Thank you so much sir its helpful

Thanks for uploading such content. It was really helpful. Keep going! Amazing video. 🔥

thank you so much sir!!!!!!!!! YOU'RE THE BEST! SHEEEEEEESH

Cool

Great Sir

Hello Frands😂😂 Ramro xa hai video. Keep it up...

👌👌👌👌🙏🏻🙏🏻🙏🏻🙏🏻

Great

Useful

Nicr

Everything is fine but when I was doing the helix at 6:22 minutes, instead of going down, the helix goes up after I type 30, what should I do?

Thanks

Now how you convert it to pdf with the point of views?

Sir unable to sweep bol rha hai