OBD2 Pin Removal

Подписаться 364

Просмотров 59 тыс.

50% 1

How to remove the pins from an OBD2 port. Designs might vary slightly depending on what you have but for the most part, this method applies to multiple platforms and models.
OBD2 Pigtail
www.amazon.ca/...
Equipment used:
DJI Mobile 3 stabilizer gimbal: amzn.to/2Vs2bzZ
Samsung Galaxy S6: amzn.to/31ohVrB
Samsung Galaxy S8+: amzn.to/31qUbTE
Lav Mic: amzn.to/31qKDYD
Using the above links will allow me to earn a little kick back from qualifying Amazon orders.

Опубликовано:

8 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 17

@Calijay707 10 месяцев назад

Much appreciated my man. No bs straight forward and not ridiculously complicated for no reason 👍🏼

@ercumentdirice8328 Месяц назад

Straight to the point. Great Video, thanks

@choizuno7782 4 года назад

Thanks for this. It really helped a lot. I'm replacing my female OBD2 in my Aveo as it broke off due to it becoming brittle.

@prince4x4 7 месяцев назад

Thanks

@ichbinbaghdady2418 4 года назад

thanks a lot

@wesrr4036 3 года назад

Txs. Very helpful!

@bigbigbulbous4051 6 месяцев назад

I'm literally sitting here putting my full strength into getting that clip off...

@macnolasco1351 3 года назад

My car doesn't bring in obd2 connector, I imagine someone removed it because in the place it should be empty. How can I do to put it back on or what wires I need to pull out

@vipercrazy 3 года назад

If your car is 1996 or newer, it should have one. Some countries may not have adopted OBD2 until later or the connector may be in a different location than you're used to. A quick Google search should be able to help you locate it.

@mattsmith6828 4 года назад

what gauge are those 16 inner wires and where do you get them?

@vipercrazy 4 года назад

I'm not entirely sure, to be honest. Probably a 28 gauge, maybe, but just a guess.

@chederdorceus9614 Год назад

Do you sell it or you just removed

@vipercrazy Год назад

No just showing how to depin connectors.

@juliusvalentinas 4 года назад

How to remove obd2 port on mazda 6?

@vipercrazy 4 года назад

I'm not overly familiar with how Mazda has mounted their ports, but doing a quick search, it appears they use a similar style to what I've seen. At each end of the connector port under the dash, you'll find a push clip you have to press to "unlock" the connector. Once those have been released, the port should slide right out. Depending where/how it's located, you may need a smaller screw driver or small pick to reach in there and release the clips.