Hello! My dear ones, I here in Brazil-Diadema-SP, use isopropyl (isopropanol) with benzine in the 1/1 proportion. I use an injection syringe to apply. And patience with the use of a knife and a small screwdriver, so I make my way. Start by opening at some point and then the product penetrates and detaches from the plastic. Hugs.
Hey bud, what is the liquid you are using? I managed to get one lens off prying it out, a little damage but acceptable. I have to do the other and would like to try using the liquid.
fake..after opening there are no leftovers from original silicon glue either on the housing or on the headlight glass...what happened to it? dissapeared?
Fake! Es ist eine unglaubliche Arbeit. Wenn Du kein Tausendsassa bist, fang nicht an. Weil Du es auch bereust, dass du angefangen hast. Die Klebereste zu entfernen auch ein Wahnsinn. Die alte Kunststoffteile brechen, wie die Grissini. Und dicht zu machen ist auch ein Glückspiel.
I used laquer thinner on a siringe and worked my way around wetting...after 3 to 5 minutes I started to ply out using two to four flat screwdrivers just to keep the preassure and rewetting with the siringe. Tape your lens or avoid laquer thinner to wet lens. It came out in less Than 20 minutes. Even old tar or glue get soft and workable.
simply has no glue left on the channel where it should prevent water come inside the headlight , if you never had opened your headlight , use hot air gun to warm up the glue and you will be able easily to take off the front cover. When you done and you want to put it back use a bit of silicone and a bit of warm up with your hot air gun and job done.
@@luistorres602 does it really work. Really need to be able to change the cover on mine without damaging the headlight. Don’t have the money to fix that😢
I think he is using Isopropanol. Look at this site at the bottom: www.perma.com/concrete/spec0022.pdf You can see that isopropanol is softening perma seal.
ага))) прям так и снял заводской герметик))) чтоб снять заводской герметик фару надо в коробку положить и направить фен минут на 20 и только после сильного прогрева он начинает отходить и то возможно 2-3 раза греть придется, а это у тебя сопли держали стекло)))