PanelView Plus & FactoryTalk View ME Introduction - 3 - Adding Alarms to an Application 

Putting the trip points in the FT View ME application is not recommended. In general this logic is done in the controller. Why? So you can change the trip point without recompiling and downloading the HMI application.

And here I was trying to make an alarm list with the default alarm banner. Now it all makes sense. SMH Thanks for the video

Great. Hope more demo are available for users that I don't have to call tech support so ofen.

Thank you very much sirji🙏

It seems you selected "Alarm List" and not "Print Alarm Status" as written in the video. Nice video anyway!

Are you really satisfied/happy with your video resolution?

Why do you hardcode the setpoints into the trigger expressions? It seems like it would make more sense to reference the "Trigger Value" column on the messages tab. Otherwise why have the "Trigger Value" column at all if it's just set arbitrarily, unless I'm missing something...

Awesome

what is "Maximum=250"; why you chose "memory"? Alarm is a binary signal right? why you chose analog? too much question no explain!