Part 3 - How To Make Your Own DIY Custom Fishing Spinners: How To Tie Tails On Your Spinners!!! 

Very good and helpful info. Thanks for sharing your methods and message with us.

I was very glad to see you witness in your video

Another great video!

Great job buddy!!

That tool is ok,but the DU-BRO Kwik Twist Fishing Tool makes smaller loops and it's like $15 on Amazon. It's a little slower because of the processes you have to go through but the baits will have more of a factory look/size to them,it can do up to .032" wire. There is one downfall with the tool though,the little button on top is brittle and can break off easily,it's only chrome or nickle brass.Had it happen to mine but after a couple minutes thinking what I could do to fix it and another 5-10min to do it it ended up better than it was originally.To fix it I just took a drill bit about the size of that button drilled down about 1/4" in the center where the button broke off.I then figured out how long that new piece was going to need and cut the end off the bit that goes into the drill (cheap cheap bit set).Then I used a dremel with a cut off wheel and add a slight groove where the wire would be riding (all the while testing the height and depth by putting it into the tool and eyeing it up).Once I was happy where it needed to be I did a test bend by putting the new piece into the hole that was drilled.If it was to high I just ground a little off the end of the piece that goes into the tool till it was right.To low and I just filled in the hole with some fine metal shavings. After all that I added a dab of JB Weld to the hole and pushed the piece in and left it cure.Later once it was dry I tested it again by making some loops and if the allen key (tool they send to twist the wire loop) was catching the new pin I just ground it down a little and rounded it over some. Now it's better than it was new,the new pin is hardened tool steel although low quality. I actually have 2 of the tools (they sent another after the 1st broke off),I use the one I repaired to finish the loops and the other I keep in a small jewelers vise just to bend the loop.

Good info on construction idea's, but I think this is the first lure video that has eternal value beyond fish. Kinda of a big deal who's the first voice you hear after you die. For me Jesus'.

Excellent how-to videos. Can't find you on Rumble. I don't subscribe to anything on RU-vid because the company is so evil.

dont need preaching on a fishing channel

thanks for the encouragement Iwas saved @ 15 but some people when they get an education think they are great thanks for the info peace brother there is a site that makes spinners I think they are butterfly spinners check him out tu lan