Passat ABS/ESP activating while driving... Fault finding and repair. 

Sir, I am from Ukraine. And I really apreciate you for that video. I will be able to fix my car by myself. Ty. But with that problem. On my passat b6 computer shiws problems with general computer block ABS. Could you advise if I will fix this sensorof ABS on my right rear wheel. All should ve fine with general block of ABS

hi can you tell me what camera you use with your autel, and is it any good? cheers

Jesus man, those brake disks... I would tell the owner definitely not to drive it until replace. Pfff

Wish I had a guy like you near me. I'm having warning light issues and all mechanics around just want to throw new parts at it, they dont even bother trying to look for the root cause. Keep up the great work

Why do people run there car's so low on fuel especially on a diesel car because it's a nightmare to get the air out of diesel pumps and the fuel system

Why every car that people bring you has to be with NO fuel? lmao Great video!

Excellent work brother I hope the owner makes it to the petrol station

Have the same problem ABS, ESP and parking brake malfunction...Hope your video will help 💪

Everybody slights Kias but all four new rotors and pads cost £120.

Guys need your help with my audi A5 took it for some suspension replacement lower control arms replaced took it for wheel alignment few days later car was making some funny noises I end up replacing upper control arm with the stabilizer after doing so the car throw engen light and esp light is on when you start the car is off but if you drive the car for few sec or when you turn the steering to right it triggers the stability lights the scanner says a lot of things like steering column and steering sensor we tried to clear the lights but keeps on coming back

Hi mate, extrimly common problem on these cars. 👍

One thing that really really works in every single car that you fix is… the fuel gage. If someday one fuel gage says it’s full, it’s definitely broken! Abraço!

Great diagnosis mate , I always few that I'm going to break something with those hub bolts they are ridiculous tight 👍

Hi Luis ... Floods did not affected your area? Great diagnosis, be careful to your injuries.

to me both sides should have been done and the brakes ,most important things on your car is brakes and steering .i am sorry but that wheel bearing would not have been getting done unless the customer was getting brakes done at same time.

Great job again Luis.I see a lot of that.I wondering that you was able to make the steering angle calibration.......bearing foult normaly makes that imposible.

Nice repair video

10/10 Luis as always. Only one warning light remained...seems like another health and safety conscious customer not wanting to store too much fuel on your premises :D

I would leave the other side, for now, Chances are something else on the car will fail before that does. I had a broken reluctor ring on my car 5 years ago the other side is still fine. The previous owner (who gave me the car) used to park next to a fence so one side of the car was sheltered from the rain.

Korosion!

Perfect man , perfect job 👌👌 Thank you very much , always learning from you .

hello, I also have these 2 dashboard lights on my volkswagen Passat b5.5 1.8 t petrol 20 v sedan, I changed the rear left wheel hub with new abs sensors, and it gave me this (open circuit/short circuit to b+) ) what if, I'm waiting for an honest answer, you have more experience than me

LUIS, AWESOME and good fix always enjoyable brother.

👍🏻👍🏻👍🏻👍🏻🌷

You can remove without removing caliper bracket the disk just comes out it a bit tight .

Louis just gets the job done...

made it an easy fix just putting a new hub on, well sorted 😊👍

Good work all ways L M, thank you for directions.

Hi, you must erase Cecilia Eisen...post.

Morning everybody

Great Video buddy...very helpful...

Great work bro keep it up !!! Good luck ! :)

Good job greeting from San Antonio texas USA

Another great video with good detail. Can't beat the maxisys, I have the MX808 and although it does not have as many functions as the maxisys, I would not buy another brand as Autel supply good diagnostic readers/coders. Had mine for a few years and to be honest not had the need to upgrade but no doubt the time will come, but one things for sure, I would stick to Autel...Great pieces of kit...

👍🌹

👍

Great content and those dreaded calliper bolts been there a few times myself.

Top technician where I can get information on ECm circuit diagram wiring diagrams schematic on so on