Pebbles installation 

Thank you:)

Solo son piedras de río con cemento de pegar cerámica... y para el brillo el con un barniz para con concreto que lo encuentras en cualquier "ferretería" no se lo como le llamen tu pais.

Thank you, thank you for advise:)

Is it mortar that’s being used? 🍃👌🏽🍃

@@MoonLeaf_RaquelLeBaudour Mapei Keraflex Sg Mortar

Use a tile set as it's strongest 💪 👌 💯 😊

​@Raquel LeBaudour a tile set mortar or regular thin set but don't mix it to soupy.

Thank you very much:)

Thank you.

Thank you:)

Thank you for comment. Cracked plates would have glaze on bought sides. The surface of the glaze is slippery and would not last long on the wall. The solution: treat the side of the plate with special primer ( tile on tile system primer) that side for adhesive to stick to or use constrictive grab adhesive like pgb and fill the gapes between plates with tile grout for exterior. I hope this information will help:)

Yes, why not, because it is the same as ceramic tiles instalation

What would you meen by thin-set?

Thank you. It is 4 square metres about and it took to do all the job about a week. If you have perfect condition and no rain it would take 4 days.

I used keraflex maxi s1 mapei, but you can use any as long as it is for exterior application

What?

What

I think its mortar

Thank you;)

I applied primer on one day, and started installation on the next day. I think it depends on primer you are going to use. You should let primer to dry completly before installation

Thanks

Yes, it could be on the patio as well, but it would be better to use concrete instead of tile adhesive. Sharp sand and cement mix 3:1 ratio mix + water , mix it. When, press the pebbles into the fresh concrete. It is better to use cobbles, it is easier to walk over bigger stones, when small. I hope it will help. When I have time, I could create video how to do it:)

I was using tiles adhesives and before used primer. If you think to use just mortar - sand and cement mix, then yes, spaying the water before application would give good adhesion.

You are welcome:)

Yes, if it would be done for interior, it would be the same as tiles installation.

Hi, thank you, I used about 60kg of pebbles.

Thank you

It is the mix of tile adhesive.

Sealant

I wouldn't be able to tell exactly, because i used leftover , but 1bag would be enough for 2.5 square metres or 1foot x 16 foot. It depends on pebble size and depth of the adhesives you apply. I hope that helps:)

thank

1bag 480cm-500cm?

1bag- 40cm x 500cm about

mapeo keraflex maxi s1 can do 400cm-500cm?

Thank you

Thank you