Congratulations and THANKS!!! Was looking to install a precision motor & controller for a low-cost rotary assembly m/c, BUT.... this is such a clever solution! I'm changing the design and going for pneumatics 🤙!!
rotate table is good idea, but i see that when the clinder back up (off), it will touch in rotate table make small movation, and may be tolerance of rotate table in the production
😀I was looking for such of a machine. Is there a parts list for this device? I know that some parts are from 8020. How long is it? How wide ? And how far off the table does it sits? Great Machine.
I love it, air cylinders are easy to adapt.The magic is in the air logic.I wish I knew air logic. I'm down with the mechanics. How do you load the rotary table? Bowl Feeder?
@@stevematson4808 I have minimal knowledge about what you spoke. would love to know where do I start with learning this pneumatics and other mechanisms
Несколько приводных ремней, несколько шестерней для синхронизации, и весь пневмо механизм с электроникой можно заменить одним двигателем, похоже я не понимаю предназначение этого устройства.
Hye n hello.. I'm a Mechatronic student.. I really love your project.. An would like to remake it again as my project but will make some upgrades like using iot dan other.. Can help me.. With some clues or maybe a scratch or cadd or anything..