Dieser Lötkolben ist nicht preiswert sondern BILLIG! Habe den Atten 2080D aufgrund dieses Videos gekauft um damit hauptsächlich Platinen und Kabel zu löten. Am Anfang hat das ganz gut geklappt, wurde aber schnell immer schlechter. Die Temperaturanzeige stimmt definitiv nicht mit der Temperatur der Lötspitze überein. Das ist auch bauartbedingt. Leute: Tut euch das Billigding nicht an und holt sofort was vernünftiges wie z.B. den Miniware TS101. Kostet ca. 80 € aber ganz andere Liga.
Ich verwende den nur gelegentlich für kleinere Sachen, und bin bis jetzt zufrieden. Kann sein daß ich einfach Glück hatte, das Ding insgesamt nicht lange genug benutzt habe oder die Chinesen haben mal wieder was an der Konstruktion geändert.
Never touched it, the handle does a pretty good job supporting the fingers and a firm grip. But the stainless steel is an somewhat bad heat carrier, and as you see by the missing discoloration behind the slots in the shaft the plate is thermally pretty much isolated. If hot it would also melt the plastic of the handle.