Тёмный

Purge Control Solenoid Valve | How to test and replace at home! | P0458 P0459 

CarsNToys
Подписаться 222 тыс.
Просмотров 2,3 тыс.
50% 1

Purge control solenoid valve testing and replacement. This video will be helpful regarding, where is the purge control solenoid valve? What does the purge control solenoid valve do? How much to replace purge control solenoid valve? What happens when purge control solenoid valve goes bad?
► Subscribe: / carsntoys
►► Tools: www.amazon.com...
Multi-meter: amzn.to/2KOdFZD
Alligator wires: amzn.to/2AQot3H
Hose pliers: amzn.to/3oSJZin
Probe kit: amzn.to/3bK6KON
Trim removal set: amzn.to/2LpY8Rn
Vacuum tester: amzn.to/34DKUab
Codes that deal with the Purge Control Solenoid Valve:
P0442 - Evaporative Emission System Small Leak Detected
P0447 - Evaporative Emission System Vent Control Circuit Open
P0448 - Evaporative Emission System Vent Control Circuit Shorted
P0456 - Evaporative Emission System Very Small Leak Detected
P0457 - Evaporative Emission System Fuel Cap Loose / Off
P0458 - Evaporative Emission System Purge Control Valve Circuit Low
P0459 - Evaporative Emission System Purge Control Valve Circuit High
P1400 - Fuel tank pressure control solenoid valve circuit low
P1420 - Fuel tank pressure control solenoid valve circuit high
P1443 - Vent control solenoid valve functin problem
What is the Purge Control Solenoid Valve:
Also known as a Valve Duty Solenoid, this valve is used to recirculate small amounts of exhaust into the combustion chambers of the engine in order to decrease the combustion temperature. This reduces nitrogen oxides & smog.
What happens when a purge control solenoid valve goes bad?
Rough idle. Hesitation. Engine surging. Common trouble codes p0458 & p0459.
►►► OTHER VIDEOS THAT MAY INTEREST YOU***
--- Wheel bearing replacement with basic hand tools:
• Wheel Bearing Replacem...
--- Choosing the best oil filter: Wix XP / Amsoil / Royal Purple..
• Choosing the BEST OIL ...
--- Touch Screen car radio install:
• How To Install A Touch...
0:11 - Locating the purge valve
1:51 - Removing the purge valve
3:47 - First test for the purge valve
5:38 - Second test for the purge valve
6:55 - Energizing the purge valve
9:25 - Testing the wiring
Note:
Any attempt to repair automotive parts and/or systems carries risk of personal injury. Always adhere and follow safe practices when working on vehicles. Such as, safety glasses, jack stands, no loose clothing, etc. No guarantee or warranty is implied. Use the information in this video at your own risk. Carsntoys is a member of the Amazon Influencer Program.
Publication, reproduction or distribution of this film is strictly prohibited.
Carsntoys
/ carsntoys
#autoreparaturtutorial #autodiy #diyauto

Опубликовано:

 

5 окт 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 14   
@miriamvivo4279
@miriamvivo4279 5 месяцев назад
Been having numerous evap issues with my 2006 stock sti . Po447,448, 442 and 456. Last 2 were resolved with my smoke machine. Other 2 cost me about $3000 ..
@jamesstewart505
@jamesstewart505 5 месяцев назад
The evap purge solenoid valve often gets stuck open. that is the most common failure, a simple check is to run the engine and check for vacuum going to the canister side port of the solenoid. if vacuum is present the valve is bad. also this valve has nothing to do with the EGR system. EGR- Exhaust Gas Recirculation.
@jamesstewart505
@jamesstewart505 5 месяцев назад
also if there was a problem with the electrical circuit it would set a different code related to the control circuit of the system. voltage too high or too low. that is a simple way to rule out an electrical problem. any time you get a code for circuit high or circuit low its an electrical issue. subaru's have an extremely complex evaporative control system. best bet is to smoke test and or use dish soap/water in a spray bottle and check for leaks with the evap system under pressure..just look for bubbles
@miriamvivo4279
@miriamvivo4279 5 месяцев назад
Currently chasing a po302 = cylinder 2 misfire
@jamesstewart505
@jamesstewart505 5 месяцев назад
Pull spark plug #2 and visually inspect plug condition. more than likely a bad ignition coil or spark plug wire.
@AsapGhostBoo
@AsapGhostBoo 5 месяцев назад
I have a 2010 Subaru Impreza and my car rattles going uphill every single time. Nothing is loose or anything any reason why?
@Tec-v3h
@Tec-v3h 5 месяцев назад
turn the music up
@jamesstewart505
@jamesstewart505 5 месяцев назад
Exhaust heat shield rattles plague just about every subaru. sounds like a bunch of bee's in a tin can
@AsapGhostBoo
@AsapGhostBoo 5 месяцев назад
@@jamesstewart505 I don't have heat shields like I said nothing is loose and no heat shields
@jamesstewart505
@jamesstewart505 5 месяцев назад
You don’t have heat shields? Did you remove them or do you have an aftermarket exhaust?
@AsapGhostBoo
@AsapGhostBoo 5 месяцев назад
@@jamesstewart505 I have aftermarket exhaust borla type s and the cats are all new Walker brand since the others were gross and 12 years old
Далее
Find The Real MrBeast, Win $10,000
00:37
Просмотров 28 млн
This mother's baby is too unreliable.
00:13
Просмотров 19 млн
Find The Real MrBeast, Win $10,000
00:37
Просмотров 28 млн