I bought new bike . I installed everything. Only problem i faced and installation was incomplete is due to ---- Slotting the Handle Bar extension into Paddle . The screw wouldnt pass through the Hole because Handlr Bar and the Rubber on paddle wont correctly slot into each other. Oys difficult. But this video is very good . Solution i will try is to slot it as shown in video . Then i will fit into cycle rod .
I ordered the exercise bike on January 7th and it arrived on February 12th. ru-vid.comUgkxzg0clhbtRf2gGxPkVETFKJJKGqdsorQu The box must have been tossed around quite a bit because one whole side of the styrofoam was destroyed, and the other side foam was cracked. The Two zip ties holding the handlebars had broken loose and handlebars were loose in the box. There are two small holes in the foam on the right side of the handlebars, I guess from rolling around inside the box. Assembly was straight forward and easy. I am 6 ft 5 in 220 lb and the handlebars and seating positions fully adjustable and work great, I'm getting full leg extension. The noise level is very, very low and acceptable. The adjustment knob for the pressure on the flywheel works well also. The exercise bike is very well made, sturdy and easy move around. This is my first exercise bike and will keep me in shape over the winter. Update 3/19/21: when removing the sticker from the wheel, make sure you remove any sticker glue also. I thought mine was clean but I was getting a slight noise from the glue. Once cleaned off, its super quite. Also the monitor didn't work, tracked it down to the pickup device wasn't in the hole. Once I moved in the hole, it works fine. Do NOT put it in until it touches or it will damage the pickup.