Redodo 50AH 12 Volt Pro Battery Review - Perfect for DIY Solar Generator Builds 

You need a zero volt lithium charger to wake up one in low voltage disconnect. I do not have one that I can remember at least.

@@rodneyhunt If you have piles of old electronic devices with little wall bricks, most of those output 12VDC and are current limited or "hicup" when over-currented, which is perfect for waking up batteries. The output voltage and current is written on the plugs. So if you can find one that outputs 12VDC at less than 2A, cut off the barrel connector on the end so you have the two wires and you can just put that on the battery for a short bit. Make sure you get the polarity right. Its virtually impossible to hurt either the battery or these little (typically less than 1A) wall warts. Alternatively if you have a bench power supply, just set it to around 12V and set the current limiting to 1A and use that. -Matt

You bet! Thank you

@@rodneyhunt Overall cost?

@@calmanny Have not calculated yet. When I complete the build I can give an update. Probably $350 give or take.

Thank you for your time, any more fishing and prepping videos? @@rodneyhunt

@@calmanny Definitely more preparedness videos in the future. Probably not fishing videos

👍

True but just like to show how a battery reacts when run down into low voltage protection. Thanks

@@rodneyhunt great testing

Thanks

Been a while but I think this BMS is only 50 amps. So max load maybe a little over 600 watts. Would need to watch again but I think my inverter for this setup is 200 watts or something. So you could definitely go bigger

The noise when the air flow hits the mic. Trying to prevent that.

I have both. The 50ah just fit better