since i did this the on and off switch is loose, alsothe bluetooth switch lose , now i am stuck on bluetooth and on, so i cannot use wired. How can I fix it? I do not see any physical switch on the board to turn it off.
the battery of my k530 is malfunctioning , can i rpelace it with a new one ? what kind of battery should i look for to replace the malfunctioning battery ?
Is it possible to fix the type C port of this keyboard? Because I had mine over a year now and it disconnects from time to time. I tried switching cables but it wasn't the cables.
Yea just a buy an usb c port from amazon disconect the white conector from the pcb and look up a tutorial on how to desolder the wires from the old port and solder them on the new one
You can pull it while lifti ng it up abit like normal but its just hard you can make it easier by removing all the switch then remove the stabs like normal but when pulling out life upwards
@@JosueRodriguez08 yes. apparently it was factory fault, for some reason the bottom side of my plate is superglued on the case. i managed to do it by using hot water and dab the part with a cotton bud, then i poke on the glued part with an exacto knife.
so my z x c v b n and m keys stopped working one day randomly no dropping no spilling, my > key wasn't working so I replaced it and then these keys stopped working out of the blue.
