Repairing a Paslode 5300 Framing Nailer

Подписаться 15 тыс.

Просмотров 9 тыс.

50% 1

I got this broken Paslode PowerMaster 5350/90S framing nail gun from a pile of free tools. The sleeve seal and bumper post were hard, cracked, and brittle. I also went ahead and replaced all the O-rings while I was in there. The repair process should be pretty much the same for any 5300 series nailer. See the links below for the parts and tools I used:
Sleeve Seal & O-Ring Kit (PN: 402011 ):
www.ebay.com/itm/160960366740
Bumper Post (PN: 500453 ):
www.ebay.com/itm/231412921074
Snap Ring Pliers:
amzn.to/3eHsQ5l (affiliate*)
*Purchasing from these Amazon affiliate links earns my channel a small commission. Think of it as a tip that doesn't cost you anything. Thanks for the support!

Хобби

Опубликовано:

31 май 2022

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 9

@Mikeattempts 2 года назад

Sleeve Seal & O-Ring Kit (PN: 402011 ): www.ebay.com/itm/160960366740 Bumper Post (PN: 500453 ): www.ebay.com/itm/231412921074 Snap Ring Pliers: amzn.to/3eHsQ5l (affiliate*) *Purchasing from these Amazon affiliate links earns my channel a small commission. Think of it as a tip that doesn't cost you anything. Thanks for the support!

@kisauer 5 месяцев назад

Thanks for the video. Helped a lot.

@Mikeattempts 5 месяцев назад

I'm glad it was helpful, thanks for the comment! :)

@ronniefoster5099 Год назад

Hi Mike. Great Video. I have the same nail gun, but the follower spring was removed and I can't seem to find a manual that shows the same magazine I have and can't figure out how to install it. When I look up 5350/90S, the magazine in the image looks different. Did you obtain a manual that shows your magazine assembly? Thanks.

@Mikeattempts Год назад

I don't have a manual that shows this exact magazine either. I'm no pro but, If I remember correctly, I think the magazine spring is just roll of flat metal that turns on a little drum. If you remove the magazine from the gun, you should see where the drum mounts at the top of the magazine. The end of the roll attaches to the follower.

@michaels5842 Год назад

Hi Mike, I have a old paslode coil roofing nalier. Any videos or info to pass along. I need parts.

@Mikeattempts Год назад

I don't currently have any coil nailers or I would happily make another video. My advice is to just take it apart, find and order any broken parts (usually just seals and bumpers), replace all of the O-rings while you're in there, and put it back together. :) eBay and Amazon are good sources for parts. Let me know how it goes!