Maybe, but who knows. The manufacturer claims that the controller board should work on variety of motors, but it doesn't say if it can power such with Hall sensor. I thing the windings of the motor should be the same, the only difference is the Hall sensor that tells the control board the position of the rotor... I'm still not that good in this subject
Good job I buyed for 90 euros 4 Einhell tools ., One screw driver , axxio flex , nail stapler, and somthing for cutting ., 18 v tools ., I'm waiting for delivery . On what spead level you left potenciometar ?
Hello. I loved this video of yours. It's a beautiful job. Now that it's been a long time, can you tell me if it's still working? I have a similar machine and would like to do the same, is there any other solution? A hug and many congratulations.
The BLDC controllers usually don’t like to to be suddenly disconnected from the battery. This is because the braking is done with charging the battery. If you disconnect it might try to brake, since the is no battery the current cant go anywhere so the only option is to raise the voltage. And with a heavy cutting disk this might be enough to get the voltage high enough to kill it.
Unfortunatelly i don't have the stock angle grinder to test. I will be doing some test with my version of the grinder, but not sure when. The weather is problem - its cold outside currently. If i do some extensive testings home I will drive my neighbours crazy :D
@@ickui need to know about the fixed grinder you done if the new controller cuts of low voltage of the battery because battery doesn't have low volt cut off
Hi, where did you order the brushless motor control board without the hall sensor? I want to put it on a milwaukee thread, that's why I need the reverse and speed control. Thanks
Eто, макар малко да са му променили радиатора, а и доста са вдигнали цената гледам :( www.aliexpress.com/item/4000299173443.html?spm=a2g0s.9042311.0.0.58344c4dRN3PSl
Не толкова добре колкото очаквах. Платката има някаква защита от претоварване(изключва), но ако човек се постарае може да я изгори - казвам го от опит хаха
Много интересно видео.Контролера е 17 долара-малко е скъп обаче видях само моторчето за 3 долара и половина ,което си е доста евтино.Регулатора на оборотите би бил доста полезен във ъглошлайфа ако успееш някак да го вградиш.Поздрави за труда
Нямам представа какъв товар може да поеме Парксайдският контролер, но определено е доста по-малко от този с 1000-та си вата. Предполагам е някъде към 500W, може и по-малко. Повечетo контролери за такъв тип машини са точно толкова - 500W. Такива имаше супер евтини в Алито, но бяха с неудобни за вграждане размери. За това се спрях на този, а той като по-мощен е респективно и по-скъп.