I'm using the RFID Card Password Access Control Machine For Door Lock. The problem that I'm facing with this unit is that whenever I restart the access control or it looses power & then gets power back is that instead of going to the "Standby state" (Blue light flashing every 1 sec / Slow flash), it goes to "Pending further action" (Green light flashing every 0.5 sec / fast flash). I'm using the terms "Standby state" & "Pending further action" from the manual that I got with the unit. When the access control is in this state whatever button I press it just makes an input beep but the green light keeps on fast flashing. During this state I can't enter the programming state. The only way to bypass this is by performing these actions: 1. get a card/tag near its rfid area & it beeps once (stating that its a valid input), but the "Pending further action" fast flash green light will still be on. 2. read the card/tag again & it beeps twice (stating that its an invalid input), but now the access control enters the "Standby state" slow flash blue light. Now I can unlock the door lock either by a registered card/tag or common password. So is there anyway to solve this? How can I change the "Pending further action" fast flash green at the power up to "Standby state" slow flash blue.