If your Tab does not switch/power ON after connecting the cable, please check the video link given below: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-6hmp-4gMR7I.html
Sir suddenly my screen popped out but all the things are working so i just have to glue the screen na no other isuue is their plz confirm fast sir please
Yes Sir, you need to glue it but please remove / clean the old sticky glue before applying new glue or adhesive, if old glue is not cleaned the screen will detach again in few days and also do not use any super glue/ epoxy or glue that hardens, try rubber based glue or the one shown in the video but cleaning old glue is important. hope this would be helpful. Thank you, have a GOODTIME....
Sir please help me my tab screencame off i put the the things as you said but its not working its not showing the display not even turning on please request help me
@@yatikaYatee-my8xr Hi, disconnect the screen, keep it aside, Remove all the screws on the other part of the tab, Disconnect the battery , Wait for a minute or two, Reconnect the battery, Fix all the screws (please do not power on the device, see that you will not even press the power key by mistake), Connect the screen flat cable, Switch ON and check if everything ok. If the device switches ON then, Switch OFF the device, Glue the screen and fix it. Hope this would be helpful. If you find it difficult to follow, please give me few days and i will try to make a video on this. Thank you, have a GOODTIME....
Sir, I have the same tab... And the screen is falling out for more than 3 years but i didn't care much about it... But today it came out completely and i somehow pressed it back.... Now the screen is not working but i can hear sounds..... Is it better to take it to a repair shop now?
If they are not replacing any parts, they should take only service(labor) charges and it differs from place to place.... Thank you, have a GOODTIME....
Hi I have a problem basically the screws under my optical drive slot are too tight to remove which makes it difficult to replace my hard disk any idea on how I can untighten them?
Hi, sorry for late reply, What is the model of your laptop ? For unscrewing see that the screw head is not damaged and the screw driver tip has not worn out, insert the screw driver firmly and give a sudden turn (like a punch) anti clock wise, if this doesn't work then try to heat the screw with pointed soldering iron/gun and try unscrewing with screw driver..... hope this will work... Thank you, have a GOODTIME...
Hello sir mere pass Samsung Tab A hai uska screen automatically detach ho gaya but my screen is allright nothing is broken sir I want to know if I go to samsung service center to glue it how much it will cost.....can you please reply quickly sir it will be very helpful I have tried to search but nothing came up only for broken screen
Hi , sorry for late reply, If you take it to samsung service center, and if everything is working fine only the screen has detached then they should charge you for adhesive tape and labor charges. I could fix it but my present location is Hubli, Karnataka. Thank you, have a GOODTIME...
Hi,@@kritiarora1918 , you need to disassemble (remove the bracket above the battery that covers even mainboard) by removing all the screws, disconnect the battery, wait for a minute and then reconnect the battery and reassemble, now the device should work fine. if the screen doesn't turn ON after this then need to check the FPC and or screen. hope this would be helpful, Thank you, have a GOODTIME....
Hi, may be the flat cable is disconnected or damaged, if it is disconnected you can try fixing it by disconnecting the battery, reconnect the display cable and then connect the battery, switch on the tab and it should work fine. If the flat display cable is damaged then there are very less chances to fix the cable, in this case you will need to replace the screen. Thank you, have a GOODTIME...
Sir, my tab the screen has come off and the screen to the cable connection is off. I tried following your steps and connect the cable but the screen is not working. Whay could be wrong?
Hello sir, may be the tab was ON when you connected the cable, disconnect the screen, disassemble the tab and reconnect the battery terminal(disconnect and reconnect the battery terminal), reassemble the tab, connect the display cable and then switch On the tab, if all works well, fix the screen. Hope this would be helpful. Thank you, have a GOODTIME....
My tab's screen hasn't completely fallen off but the top right corner is starting to come off . So what should I do ? , is there a need to completely remove the screen ?
Hi, If the ribbon is fixed properly then may be the tab was ON while fixing the ribbon, not to worry, now disconnect the ribbon, keep the display aside safely, remove all the screws that you see, take out the cover, disconnect the battery terminal from mainboard, wait for a minute, reconnect the battery terminal to mainboard, fix back the cover and fasten the screws, See that you DO WILL TURN ON THE DEVICE BY ACCEDENTLY PRESSING THE POWER KEY. or purposely. Now connect the ribbon, Power ON and check, it should work. if all is OK then fix the screen. Thank you, have a GOODTIME....
Hi, If the ribbon is fixed properly then may be the tab was ON while fixing the ribbon, not to worry, now disconnect the ribbon, keep the display aside safely, remove all the screws that you see, take out the cover, disconnect the battery terminal from mainboard, wait for a minute, reconnect the battery terminal to mainboard, fix back the cover and fasten the screws, See that you DO WILL TURN ON THE DEVICE BY ACCEDENTLY PRESSING THE POWER KEY. or purposely. Now connect the ribbon, Power ON and check, it should work. if all is OK then fix the screen. Thank you, have a GOODTIME....