ScanGauge3 Updating Firmware and X-Gauge Programming

NJS Instructional

Подписаться 17 тыс.

Просмотров 9 тыс.

50% 1

Видео Поделиться Скачать Добавить в

Опубликовано:

28 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 22

@kman6482 Год назад

Geeeez, awesome video champ. I was dreading the setup when my gauge turns up. Cheers.

@NJSInstructional Год назад

Glad it helped

@g5gs334 Год назад

Great Scangauge video guide. Very helpful. Thank you 👍

@NJSInstructional Год назад

Glad it was helpful!

@topspeed2500 Месяц назад

Good job man much appreciated👍🏻

@NJSInstructional Месяц назад

Cheers!

@andrewcrane3489 Год назад

What is the difference between A/T Temp 1 and A/T Temp 2? On my 4Runner there is up to a 30 (Fahrenheit) degree temperature difference.

@kenxx2508 10 месяцев назад

Hey man where did you find the TXD on your MUX starting with 621? On the website for GM specific TXD starts with 07E.

@NJSInstructional 10 месяцев назад

It may be a typo / error on my behalf, or it may have changed on the website. I'm not sure, however, with the MU-X, you can select your brand of vehicle with X-Gauge and it already has them pre-configured...

@toddincabo Год назад

Thanks man, could you do a video on setting an alarm and the different sounds they make, can you adjust the sound volume.

@harryarmytage2963 Год назад

Do you know what exactly the ATF1 & 2 measure -I assume 1 is the pan and 2 is the torque converter is thus correct?

@NJSInstructional Год назад

ATF Temp 1 reads from the Transmission's Oil Pan Sensor, and AFT Temp 2 reads from the Transmission's Torque Convertor Sensor.

@harryarmytage2963 Год назад

Thanks

@festeradams3972 Год назад

Any feedback on using a Scangauge with a Nissan Leaf EV, or any other EV?

@TomTWilson 11 месяцев назад

I see you made a simple fault clear the codes etc.... will this clear BCM codes? cheers

@NJSInstructional 11 месяцев назад

I believe it may be different for each Manufacturer, depends on what Codes they are willing to provide access to...

@kman6482 9 месяцев назад

So after using this unit, I found that the engine temp and auto trans codes are incorrect. I have ceased using it.

@NJSInstructional 9 месяцев назад

Reach out to ScanGauge, I'm sure they will be willing to help you out.

@mah3329 5 месяцев назад

Hello my friend Where can I find the link at minute 3:52?

@NJSInstructional 5 месяцев назад

You can find more here: www.scangauge.com.au/x-gauge-commands/

@harryarmytage2963 Год назад

great video thanks

@NJSInstructional Год назад

Cheers, thank you!