In this video explained about ATV320 Drive Basic Programming/Parameter Setting, Configure for 2-Wire Control for Start/Stop & Potentiometer Connection for Frequency Refrence.
I'm using atv320 I can't see UFT *sensors essentially vector control* in drc menu. I have set motor control type ctt to expert . What might be the reason?
I faced one issue with this vfd..from local it working but I can't able to run it through PLC.. At DI 4 to 20ma a got while increase or decreasing the frequency from control room. Can u help me on this..??
Dear please do as below: Cause: NLP means no line power or no line voltage. The drive thinks that there is no input voltage coming into the drive. Resolution: Check and verify the line voltage on L1, L2 and L3 of the drive. Go to the MON menu and check the ULn Mains voltage to see what the drive thinks the main voltage is. Verify DC bus voltage on PA+ and PC-.
@@j.s.electricalinstrumentat2146 I have checked L1, L2 & L3 and it's showing 415V, ULn is 242V, DC Bus voltage is 345.5V. Now please let me know if it's ok or not, where is the problem.
hello sir my Bangladesh se bol raha hoo,, Altivar ATV 320 lekar main bahut problem mein hun sar, mujhe aap ki madad ka bahut jarurat hai sar,, please help me 🙏🙏🙏
