No video :(

Seat Arosa/ VW Lupo stiff gear change. How to Fix it!

Подписаться 37

Просмотров 28 тыс.

50% 1

Seat Arosa suffering from a stiff gear change. I took the gear selector off to find part of the mechanism was seized into the bushing. To fix this issue you have to remove the shaft, file down the inside of the nylon bush, apply some grease and make sure it moves free. I hope this helps others out.

Опубликовано:

2 дек 2017

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 27

@TheKillerCZ 3 года назад

Thanks, i had the same problem on my Polo 6N2. I also lubricated bowden cable rods and now i can shift easily with one finger.

@chrispbits 2 года назад

Thanks for uploading this just fixed mine and can now shift freely Tip for anyone else doing this the top bolt on the mechanism is easier to access from above

@marvineliahoppe7405 3 года назад

Thanks a lot, had the same issue and fixed it with the help of your video

@tommymoto41 Месяц назад

Great video, what holds that shaft in, is there a circlip on the other end ?? My lupo gears are all tight, thought it might be the cables. But will look at what you did first. Many thanks

@vw_beetle_dave 5 лет назад

Thanks just picked up a Lupo that’s doing the same. Will give this a go.

@vw_beetle_dave 5 лет назад

looked at lupo and its not the same parts as yours . its one of the arms that slides i think is the prob the one that is held on with a pic not bolted on

@fastcoast 4 года назад

Possibly a different engine? I think this was a 1litre.

@TCK8287 3 года назад

Im having the same prob. with my 6n2 polo, thank you for the vid！

@SeanyVTV 3 года назад

Great video! I have a similar issue but I can't seem to get it to stay in reverse gear. Having to hold it in when reversing, and even then it slips. Don't suppose you would have any ideas or usual causes? Its a lupo 02 1.7 SDI. Thanks again for sharing!

@daigosaito888 2 года назад

Mines stick/lever is rlly smooth. But the clutch travels like 20cm down before engaging, and then 1 cm up before hooking with the engine. After that theres like 20cm of complete mysteryland where i have no idea why the clutch is still not letting go

@daigosaito888 2 года назад

Basically i revv the engine super much and then dump the clutch. This is areason i want to sell my Lupo

@benjaminpicton7235 Год назад

@@daigosaito888 get a new clutch disc and clutch cable, i had the exact same issue bro, its hard to drive but once that issue is fixed the car will be a joy, much better than the modern crap for sale nowadays.

@samknight2573 4 года назад

How did you set up the gear linkage to the cable on refitting, as they are on sliders?

@fastcoast 4 года назад

This was a while back. From what I can remember I just disconnected everything in neutral. The gear linkage cables pop off. I made a note of the position of the mechanism that attaches to the transmission before taking it all apart. I hope that makes sense.

@samknight2573 4 года назад

@@fastcoast yes thank you, In the end I put the gearstick on neutral then put my gearbox in neutral then lined it up, many thanks for the vid