SENA 50S - UNBOXING & INSTALL | Shoei RF-SR and Shoei RF-1200 

do you like your Sena unit? Great video. helped me figure out my old system a bit better (until we upgrade).

Hello! Thank you for the video! Helped a lot to get started. I have a 1200 myself (and my gf has the 1400) and found that the cheek pad construction on it is in the way of the adhesive mounting plate. I slowed through your set up of your wife's and saw you struggled getting the two hex screws on over the grey mesh part of the helmet. So did I, and by forcing it I ended up snapping the inner foam mould, near the ear/cheek. I also noticed you didn't get full contact with the sticky tape because of the same issues. Mine came off almost half way after the first ride. The solution? Mounting it under the visor latch, but that's cumbersome for obvious reasons. In contrast the 1400 was designed with more of these intercom mounting locations considered. The inner liner is in two pieces which allows for better cable routing and the visor latch is centred so the unit doesn't get in the way. Let me know how it went with your wife's RF-1200.

I intend to purchase the Sena 50s,is this the newest that Sena has,I dont want to buy this and this b outdayed shortly afterwards....

Great job 👍

I had the same issue as a comment above with ear pain after installing on the foam ear cover piece. So i just installed it into the speaker cutout as intended, but my helmet is WAY louder with wind noise. Did you ever experience and/or resolve that?

Do the speakers hurt your ears after a while on the RF-SR? I originally installed the speakers on top of the original foam ear pads but the speakers would jut into my ear making it super painful. I've since removed the foam and just stuck the speakers directly onto the recessed area underneath the foam but it still sticks out too far for comfort, not to mention folding my ears when I put on my helmet.