A guide on how to make the, HP DPS-800GB Rev. A, server power supply run outside of its server enclosure. A simple bridge between pin 31 and 34 is required and it is important to NOT drill holes through the GND and +12VDC output pads, this will risk short-circuiting the output as its a 4-layer PCB.
Discussion and schematic: highvoltagefor...
↝↝ Additional information and links ↜↜
★ Partners: @arcattackmusic and @franzolielectronics
★ Music by Mikas: / mikasdk (used with commercial permission)
★ T-Shirts, mugs and other merchandise: teespring.com/...
★ Electronics website: kaizerpowerele...
★ Facebook: / kpedk
★ High Voltage Forum: highvoltagefor...
★ My Slow motion videos channel: / @slowmotionvideosdk
★ Find me at Odysee: odysee.com/@Ka... and odysee.com/@Sl...
★ Find me at LBRY: lbry.tv/@Kaize...
$ For commercial/non-commercial licensing of material, contact through here: kaizerpowerelec...
♥ Donations
Please consider one of the following:
♥ Donate via Paypal: fleex@disorder.dk
♥ Donate crypto currency directly on these addresses (Check if there is minimums before transfer):
• Bitcoin: 36gKDS4PfmPdmi2YC9kRASNV9Au8rUXbBS
• Litecoin (old): 3MHsQ1xhPvoqUv51dXJHAHZf2QXLZ7UEbo
• Litecoin (new): MTW1huNfM3fGHRLujQHcyvp4M77nYpLTGF
#electronicscreators #server #psu #diy
2 окт 2024