Session #1: Basic Start Up & Programming - Sysmac Studio Online Training 

Im an electrician by trade and work along side programmers everyday, this video has opened my eyes a bit more to the wonderful world of programming. To any sparkies in a similar situation i recommend watching this. Thanks for posting this video

This helped me out so much. I've only programmed in TIA16 and my teacher threw me an Omron PLC and said figure this one out. Would have taken me so long if I would'nt have found this. +rep

Amazing video! Informative.

wow, great video! thanks a lot for sharing.

Thank you so much for sharing this!

Great video! Thank you

Excellent video! Thank you

Thanks for your video

Super video bro, nice

Great upload

Today at work I was connected to Controller via ethernet switch so I chose the connection via hub and the connection didnt want to work :D Then I switched on direct connection and it worked perfectly

Hola. Puedes crear un entrenamiento exclusivo de Motion control. Sería de gran ayuda... éxitos...👍👍

Thanks so much for this video. When I go to simulation, it starts, but it doens't run. It's like if I was in stop mode. How can I solve this? Thanks.

I dont understand the file system. How do I navigate between projects, once I have opened a project?

For EtherCAT is there a special cable or normal Ethernet cat 6 cable can be use?

is there a way to send data from a pc to plc (like a variable or some value which is to be used in ladder logic)?

42:31