I cannot get below 1160 or above 1950 for some channels and although I have all midpoints at 1500 the copter still drifts considerably How could this happen ??
Hi I need some help with setting up my tinyhawk 2. I dont know if anyone can help but I think I have messed it up because when I try to bind it to my radio it wont bind because I only have a red light flashing so my radio does not see it but in betaflight its there. What happened was I had it setup on my radio and all was fine but I could not get the throttle to respond from my radio but everything else was fine so silly me reset the hawk in betaflight then I had to reflash it all for betaflight to see it again but when i plug the battery in after the blue/green and red lights start but then just the red stays flashing and I can not bind to the hawk. I dont know how to fix this and wished I had not reset it but Im new at the hobby thats why I made the silly mistake. Any ideas how I might sort this out. Thanks
You need to make sure you've got matching international or EU firmware on the receiver and transmitter. They use slightly different protocols and if they're different they won't bind. Id did a video on this ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-B054usk4Fe4.html
Hello if anyone can help me with this would be awesome. My problem is that nothing happens when I change the minimum value or the maximum value on some channels. I cant get 1000 and 2000. Any ideas? I have reflashed re binded and everything is ok, But cant change the value on some channels. x9dplus with r9m and R9stab reciver
@@michaeldyer6079 The easiest way to find what's stopping the quad arming is using the CLI in the betaflight. Type in status and it will show you the arming disable flags. You can look up the disable codes here github.com/betaflight/betaflight/wiki/Arming-Sequence-&-Safety Hopefully it'll give you a clue what's preventing your quad arming.